PAC (Programmable Automation Controller) Series – I/O Modules

Enter into the IoT Era with a Real Time Controller

PAC (Programmable Automation Controller) Series

IEC 61131-3 standard CODESYS programming.Rich functionality to build an open system in an industrial application.

I/O Modules / Options

I/O Modules

I/O interface expansion modules of the configurable type controllers.
24VDC power is supplied by the controller to the attached I/O modules via the internal bus.

Analog Input and Output Modules

CTR M2M controller series M2M Gateway series PAC PAC series Edge series

Model	Input	Output	Power Consumption	Connectors	Controller series
CPS-AI-1608LI	8-ch differential input, 16-bit resolution, ±10V Bus isolated	―	100mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)	CTR GW PAC EG
CPS-AI-1608ALI	8-ch differential input, 16-bit resolution, 0 to 20mA Bus isolated	―	100mA (Max.)
CPS-AO-1604VLI	―	4-ch voltage output, 16-bit resolution, ±10V Bus isolated	200mA (Max.)
CPS-AO-1604LI	―	4-ch current output, 16-bit resolution, 0 to 20mA Bus isolated	200mA (Max.)

Sensor Module

Model	Supported sensor / wiring method	No. of CH / Isolation	Power Consumption	Connectors	Controller series
CPS-SSI-4P	Pt100 / Three-wire or four-wire	4ch / Bus isolated	100mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)	CTR GW PAC
CPS-SSI-4C	Thermocouple input / Type : J,K,E,N,R,S,T	4ch / Bus isolated	100mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)	CTR GW

Model

Supported sensor / wiring method

No. of CH / Isolation

Power Consumption

Connectors

Controller series

CPS-SSI-4P

Pt100 / Three-wire or four-wire

4ch / Bus isolated

100mA (Max.)

Screw terminal block
(3.81mm/0.15″ pitch)

CTR

PAC

CPS-SSI-4C

Thermocouple input /
Type : J,K,E,N,R,S,T

4ch / Bus isolated

100mA (Max.)

Screw terminal block
(3.81mm/0.15″ pitch)

CTR

Digital Input and Output Modules

Model	Input	Output	Power Consumption	Connectors	Controller series
CPS-DIO-0808L	8-ch Opto-isolated (Compatible with current sink output)	8-ch Opto-isolated open-collector (Current sink type)	100mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)	CTR GW PAC EG
CPS-DIO-0808BL (Built-in 12VDC power)	8-ch Opto-isolated (Compatible with current sink output)	8-ch Opto-isolated open-collector (Current sink type)	200mA (Max.)
CPS-DIO-0808RL	8-ch Opto-isolated (Compatible with current source output)	8-ch Opto-isolated (Current source type)	100mA (Max.)
CPS-DI-16L	16-ch Opto-isolated (Compatible with current sink output)	―	100mA (Max.)
CPS-DI-16RL	16-ch Opto-isolated (Compatible with current source output)	―	100mA (Max.)
CPS-DO-16L	―	16-ch Opto-isolated open-collector (Current sink type)	100mA (Max.)
CPS-DO-16RL	―	16-ch Opto-isolated (Current source type)	100mA (Max.)

Relay Module

Model	Input	Output	Power Consumption	Connectors	Controller series
CPS-RRY-4PCC	―	4-ch Relay contact output (1 pair of Form c contacts)	100mA (Max.)	Screw terminal block (50.8mm/0.2″ pitch)	CTR GW PAC EG

Model

Input

Output

Power Consumption

Connectors

Controller series

CPS-RRY-4PCC

―

4-ch
Relay contact output (1 pair of Form c contacts)

100mA (Max.)

Screw terminal block
(50.8mm/0.2″ pitch)

CTR

PAC

Counter Module

Model	Input	Output	Power Consumption	Connectors	Controller series
CPS-CNT-3202I	Phase A/Up 1×2ch Phase B/Down 1×2ch Phase Z/CIR 1×2ch General input 1×2ch Optocoupler isolated between channels	Match signal output 1×2ch (Opto-isolated open-collector output)	100mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)	CTR GW PAC EG

Model

Input

Output

Power Consumption

Connectors

Controller series

CPS-CNT-3202I

Phase A/Up 1×2ch
Phase B/Down 1×2ch
Phase Z/CIR 1×2ch
General input 1×2ch
Optocoupler isolated between channels

Match signal output 1×2ch
(Opto-isolated open-collector output)

100mA (Max.)

Screw terminal block
(3.81mm/0.15″ pitch)

CTR

PAC

Serial Communication Modules

Model	Transmission Scheme	No. of CH / Isolation	Power Consumption	Connectors	Controller series
CPS-COM-1PC	RS-232C Asynchronous serial transmission	1ch / Bus isolated	100mA (Max.)	9-pin D-SUB connector(s)	CTR GW PAC EG
CPS-COM-2PC	RS-232C Asynchronous serial transmission	2ch / Bus isolated Isolated between channels	200mA (Max.)	9-pin D-SUB connector(s)
CPS-COM-1PD	RS-422A / RS-485 Asynchronous serial transmission (Full duplex / Half duplex)	1ch / Bus isolated	200mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)
CPS-COM-2PD		2ch / Bus isolated Isolated between channels	200mA (Max.)	Screw terminal block (3.81mm/0.15″ pitch)

LoRa Communication Modules

Model	Wireless System	Frequency band / Modulation method	No. of Channels	Power Consumption	Connectors	Controller series
CPS-COM-1QL(Japan only)	ARIB STD-T108	920.6 to 923.4MHz LoRa (Spread Spectrum)	15ch (at 62.5 and 125kHz bandwidth) 7ch (at 250kHz bandwidth) 5ch (at 500kHz bandwidth)	100mA (Max.)	SMA connector	CTR GW

Model

Wireless System

Frequency band /
Modulation method

No. of Channels

Power
Consumption

Connectors

Controller
series

CPS-COM-1QL(Japan only)

ARIB STD-T108

920.6 to 923.4MHz
LoRa
(Spread Spectrum)

15ch (at 62.5 and 125kHz bandwidth)
7ch (at 250kHz bandwidth)
5ch (at 500kHz bandwidth)

100mA (Max.)

SMA connector

CTR

*24VDC power is supplied by the controller to the attached I/O modules via the internal bus.

Insulation Deterioration Monitoring Module for Three Phase Induction Motor + ZCT Sensor

Model	The Measured Circuit	No. of measured circuit	Inner diameter of ZCT	Measurement voltage range	Measurement leakage current range (Resolution: 0.001mA)	Measured insulation resistance range	Controller series
CPS-MM-LC	Overall equipment measurement (power supply mode) / Inverter output section measurement (inverter mode)	1ch	Φ25mm (Φ0.98”)	Line voltage 10VAC or more, 600VAC or less	Overall equipment measurement: 0 to less than 1A Inverter output section measurement: 0 to less than 100mA	Less than 1,000MΩ^*	CTR GW

Model

The Measured Circuit

No. of
measured
circuit

Inner
diameter
of ZCT

Measurement
voltage range

Measurement leakage current range
(Resolution: 0.001mA)

Measured
insulation
resistance range

Controller
series

CPS-MM-LC

Overall equipment measurement
(power supply mode) / Inverter output
section measurement (inverter mode)

1ch

Φ25mm
(Φ0.98”)

Line voltage
10VAC or more,
600VAC or less

Overall equipment measurement:
0 to less than 1A
Inverter output section measurement:
0 to less than 100mA

Less than 1,000MΩ^*

CTR

*The guaranteed accuracy range is less than 10MΩ

IoT Solution：Three-Phase Motor Breakdown Prediction Monitoring

Options

Power Supplies

Model	Input	Output	Physical Dimensions(mm)	Mount Method	Support Products
CPS-PWD-15AW12-01	85 to 264VAC	12VDC、 1.3A (Max.)	39.0(W)×80.0(D)×79.0(H) (1.54″x3.15″x3.11″) (does not include protrusions)	Mountable to a 35mm DIN rail	Integrated type controllers
CPS-PWD-30AW24-01		24VDC、 1.3A (Max.)	22.5(W)×75.0(D)×90.0(H) (0.89″x2.95″x3.54″) (does not include protrusions)		Configurable type controllers
CPS-PWD-90AW24-01		24VDC、 3.8A (Max.)	50.0(W)×90.0(D)×90.0(H) (1.97″x3.54″x3.54″) (does not include protrusions)		Configurable type controllers

*A DC cable and a 3-pin I/O connector are included.
*AC power cable is not included. An optional AC power cable is available from Contec (IPC-ACC0DE3).

AC Power Cable

Model	Rating	Cable Length	Terminals	Support Product
IPC-ACCODE3	125VAC 7A	2m	3-pole round terminal	Power supplies

IO-Link Master

Model	Supported protocols	No. of CH	Specification
CPSL-08P1EN	CC-Link IE Field Basic EtherNet/IP Modbus TCP PROFINET EtherCAT OPC UA server	8ch	IP67 compliant

Roof Top Antenna

Model	frequency band	Cable Length	Antenna Gain	Physical Dimensions(mm)	Support Products
CPS-ANT-R3-01	800MHz band 920MHz band 2.1GHz band	3m	800MHz band: 3.88dBi 920MHz band: 3.02dBi 2.1GHz band: 3.76dBi (Don’t include cable loss)	42.0(W)×42.0(D)×93.0(H) (1.65″x1.65″x3.66″) (Not including protrusions and cable)	920MHz models 3G WAN models 4G LTE WAN models

Connection Cable for FANUC CNC

Model	Cable Length	Specification	Support Products
CPS-CAB-S01-1	1m	20-pin to 9-pin conversion cable (Software flow control, one touch lock type)	OPC UA server built-in models
CPS-CAB-S01-3	3m
CPS-CAB-S01-5	5m

Connection Cable for Mitsubishi Electric CNC

Model	Cable Length	Specification	Support Products
CPS-CAB-S02-1	1m	20-pin to 9-pin x2 conversion cable (Software flow control, one touch lock type)	OPC UA server built-in models

Magnet (for mounting)

Model	Number	Support Products
CPS-MAG01-4	Four	Integrated type controllers

PAC (Programmable Automation Controller) Series – I/O Modules

PAC (Programmable Automation Controller) Series

I/O Modules / Options

I/O Modules

Analog Input and Output Modules

Sensor Module

Digital Input and Output Modules

Relay Module

Counter Module

Serial Communication Modules

LoRa Communication Modules

Insulation Deterioration Monitoring Module for Three Phase Induction Motor + ZCT Sensor

Options

Power Supplies

AC Power Cable

IO-Link Master

Roof Top Antenna

Connection Cable for FANUC CNC

Connection Cable for Mitsubishi Electric CNC

Magnet (for mounting)

Login

Reset Password